Suzuki Ignis Service Manual page 1194

Rg413
Table of Contents

Advertisement

AIR CONDITIONING (OPTIONAL)
WARNING:
For vehicles equipped with Supplemental Restraint (Air Bag) System:
• Service on and around the air bag system components or wiring must be performed only by an
authorized SUZUKI dealer. Refer to "Air Bag System Components and Wiring Location View" under
"General Description" in air bag system section in order to confirm whether you are performing ser-
vice on or near the air bag system components or wiring. Please observe all WARNINGs and "Ser-
vice Precautions" under "On-Vehicle Service" in air bag system section before performing service
on or around the air bag system components or wiring. Failure to follow WARNINGs could result in
unintentional activation of the system or could render the system inoperative. Either of these two
conditions may result in severe injury.
• Technical service work must be started at least 90 seconds after the ignition switch is turned to the
"LOCK" position and the negative cable is disconnected from the battery. Otherwise, the system
may be activated by reserve energy in the Sensing and Diagnostic Module (SDM).
CAUTION:
The air conditioning system of this vehicle uses refrigerant HFC-134a (R-134a).
None of refrigerant, compressor oil and component parts is interchangeable between two types of A/
C: one using refrigerant CFC-12 (R-12) and the other using refrigerant HFC-134a (R-134a).
Be sure to check which refrigerant is used before any service work including inspection and mainte-
nance. For identification between these two types, refer to "Refrigerant Type Construction" in this
section.
When replenishing or changing refrigerant and compressor oil and when replacing parts, make sure
that the material or the part to be used is appropriate to the A/C installed in the vehicle being serviced.
Use of incorrect one will result in leakage of refrigerant, damage in parts or other faulty condition.
NOTE:
For the items with asterisk (*) in the "CONTENTS" below, refer to the same section of the Service Man-
ual mentioned in the "Foreword" of this manual.
General Description ........................................1B-3
Refrigerant Type Construction ............................ *
Air Conditioning System Description................... *
Major Components of A/C System................ 1B-3
A/C System Wiring Circuit Diagram .............. 1B-4
Diagnosis .........................................................1B-6
A/C System Symptom Diagnosis .................. 1B-6
Abnormal Noise Diagnosis of A/C System.......... *
Abnormal noise from compressor ................... *
Abnormal noise from magnetic clutch ............. *
Abnormal noise from tubing ............................ *
Abnormal noise from condenser
assembly ......................................................... *
SECTION 1B
CONTENTS
Abnormal noise from crankshaft pulley ........... *
Abnormal noise from tension pulley ................ *
Abnormal noise from A/C evaporator.............. *
Abnormal noise from blower motor ................. *
A/C System Performance Inspection .................. *
Performance diagnosis table .......................... *
On-Vehicle Service ......................................... 1B-8
Operation Procedure for Refrigerant
Charge .......................................................... 1B-8
Recovery ......................................................... *
Replenishing compressor oil ..................... 1B-9
When replacing other part............................... *
Evacuation of A/C system ............................... *
AIR CONDITIONING (OPTIONAL) 1B-1
0A
0B
1A
1B
3B
3D
3E
3F
4A
5
5A
5B
5C
6
6A1
6B

Advertisement

Table of Contents
loading

Table of Contents