Suzuki Ignis Service Manual page 1094

Fig. for STEP 3
NOTE:
Upon completion of inspection and repair work, perform following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Repeat AIR BAG DIAGNOSTIC SYSTEM CHECK to confirm that the trouble has been corrected.
Table B :
Step
1 1) Set parking brake.
2) Note combination meter when ignition
switch is turned ON.
Does the "BRAKE" indicator (warning lamp)
come ON?
2 1) With ignition switch OFF, disconnect SDM.
2) Check electrical connection check mecha-
nism.
Is it in good condition?
3 1) Disconnect SDM.
2) Check proper connection to SDM at termi-
nal "Q06-2".
3) If OK then check voltage from "Q06-2" ter-
minal of SDM connector to body ground
with ignition switch ON.
Is it 8 V or more?
4 1) Remove combination meter. Refer to COM-
BINATION METER in SECTION 8.
2) Check proper connection to combination
meter at "YEL/BLK" terminal for "AIR BAG"
warning lamp and to SDM at terminal "Q06-
2".
3) If OK then check resistance between "YEL/
BLK" wire terminal of combination meter
connector (16-pin connector) and "Q06-2"
terminal of SDM connector.
Is resistance 1 Ω or less?
Special tool
(A) : 09932-76010
Action Yes
Go to step 2.
Go to step 3.
Substitute a known-good
SDM and recheck.
Go to step 5.
AIR BAG SYSTEM 10B-17
No
"BLK/WHT" wire, "IG
METER" fuse or J/B
(between ignition switch
and combination meter)
open or short to ground
Repair electrical connec-
tion check mechanism.
Go to step 4.
Repair high resistance or
open in "YEL/BLK" wire
circuit (between combina-
tion meter and SDM).