Table of Contents
Advertisement
3B-2 MANUAL RACK AND PINION
On-Vehicle Service
Tie Rod End Removal and Installation
Installation
1) Install tie rod end lock nut (1) and tie rod end (2) to tie rod
(3). Align lock nut with mark (4) on tie rod thread.
2) Connect tie rod end to knuckle. Tighten new tie rod end nut
(1) to specified torque.
Tightening torque
Tie rod end nut (a): 40 N·m (4.0 kg-m, 29.0 lb-ft)
3) Inspect for proper toe (Refer to "Front End Alignment").
4) After confirming proper toe, tighten tie rod end lock nut to
specified torque.
Tightening torque
Tie rod end lock nut (a): 45 N·m (4.5 kg-m, 32.5 lb-ft)
5) Tighten wheel bolts to specified torque and lower hoist.
Tightening torque
Wheel bolt: 95 N·m (9.5 kg-m, 69.0 lb-ft)
Steering Gear Case Removal and Installation
(for Diesel Engine Model)
Removal
CAUTION:
Be sure to set front wheels in straight direction and
remove ignition key from key cylinder before these steps,
otherwise contact coil of air bag system may get dam-
aged.
1) Slide driver's seat as far back as possible.
Advertisement
Table of Contents
