Table of Contents
Advertisement
7B-114 AUTOMATIC TRANSMISSION (4 A/T)
5) Install differential side L bearing (1). Press-fit it by using spe-
cial tool and copper hammer.
Special tool
(D) : 09924-74510
(E) : 09926-68310
.
2. Differential case
6) Press-fit new sensor rotor (1) with groove (2) side downward
as shown by using special tools and copper hammer.
Special tool
(F) : 09951-76010
(G) : 09940-54910
7) Support differential assembly as illustrated so as to float L
bearing, and then press-fit R bearing by using special tool
and copper hammer.
Special tool
(D) : 09924-74510
(E) : 09926-68310
(H) : 09951-16060
1. Differential side R bearing
2. Speedometer sensor rotor
3. Differential pinion shaft pin
8) Hold differential assembly with soft jawed vise (3), install
final gear (2) and then tighten it with 8 bolts to which thread
lock cement is applied to specified torque.
CAUTION:
Use of bolts other than specified ones is prohibited.
Tightening torque
(a) : 90 N·m (9.0 kg-m, 65.0 lb-ft)
"A" : Thread lock cement 99000-32110
1. Final gear bolt
4. Differential case
5. Differential side L bearing
Advertisement
Table of Contents
