Suzuki Ignis Service Manual page 1704

Test Work Order Description
T01 • Use the following table to obtain the concerned functional group
and perform the following additional test steps, while performing
the troubleshooting in the C-x tables.
Refer to Table B-01, Diagnostic Trouble Code
Refer to Table B-02, Data List
Move the related connectors, wiring harness and components in
order to find the failure. Switch on all electric consumers by turns,
because this can cause an electromagnetic interference in a cir-
cuit. Use an oscilloscope to observe the wiring harness for distur-
bances. Operate the system under different conditions over a
considerable time.
Symptoms/Customer Complaints
• Check if one of the symptoms in the following table match the pre-
viously recorded customer complaint and perform the following
additional test steps, while performing the troubleshooting in the C-
x tables.
Refer to Table B-09, Symptom Chart/Customer Complaints
Move the related connectors, wiring harness and components in
order to find the failure. Switch on all electric consumers by turns,
because this can cause an electromagnetic interference in a cir-
cuit. Use the oscilloscope to observe the wiring harness for distur-
bances. Operate the system under different conditions over a
considerable time.
After successful test/fault repair proceed to the next test step
Yes: –
ENGINE GENERAL INFORMATION AND DIAGNOSIS (Z13DT ENGINE) 6-3-45
Nominal Value
No: –