Suzuki Ignis Service Manual page 1119

10B-42 AIR BAG SYSTEM
DTC B1043 and B1047 :
Step
1 1) With ignition switch OFF, remove center pil-
lar inner garnish of applicable side then dis-
connect seat belt pretensioner connector.
2) Check proper connection to applicable seat
belt pretensioner at terminals in "Q05" or
"Q07" connector.
3) If OK then connect Special Tool (B) to seat
belt pretensioner connector disconnected at
the step 1.
With ignition switch ON, is DTC B1043 or
B1047 still current?
2 1) With ignition switch OFF, disconnect Spe-
cial Tool (B) and SDM.
2) Measure resistance between "Q06-11" or
"Q06-6" and body ground.
Is resistance 10 Ω or more?
Fig. for STEP 1 and 2
Fig. for STEP 2
[A] : For DTC B1043
[B] : For DTC B1047
Special tool
(A) : 09932-76010
(B) : 09932-75010
Action Yes
Go to step 2. Ignition switch OFF.
Replace seat belt pretensioner
(Refer to Section 10).
Substitute a DTC B1043 :
known-good SDM Repair short "GRN/YEL" or "GRN/
and recheck. ORN" wire circuit to ground.
DTC B1047 :
Repair short from "BLU/YEL" or
"BLU/ORN" wire circuit to ground.
No