Table of Contents
Advertisement
7A-24 MANUAL TRANSMISSION
6) Install 3rd gear needle bearing of resin cage type, apply oil to
it, then install 3rd gear (1) and synchronizer ring (2).
7) Drive in high speed sleeve & hub assembly (3) by using spe-
cial tool and hammer, facing long flange side of hub to 3rd
gear.
NOTE:
• While press-fitting sleeve & hub, make sure that syn-
chronizer ring key slots are aligned with keys in sleeve
& hub assembly.
• Check free rotation of 3rd gear after press-fitting
sleeve & hub assembly.
• Synchronizer rings for 3rd and 4th are identical.
Special tool
(B) : 09913-84510
[A] : 3rd gear side
A : Key way
B : Long flange
C : Projecting end
8) Install circlip (1) and confirm that circlip is installed in groove
securely.
Install needle bearing (2) of steel cage type, apply oil to
bearing and then install synchronizer ring (3) and 4th gear
(4).
9) Press-fit left bearing (2) by using special tool and hammer.
Special tool
(C) : 09925-98221
10) Using the same special tool, drive in 5th gear spacer (1).
CAUTION:
To prevent 5th gear spacer from being distorted because
of excessive compression, do not press-fit it with left
bearing at once.
Advertisement
Table of Contents
