Table of Contents
Advertisement
3
2
1
1
4) Using special tool, remove circlip (1).
Special tool
09900-06107
5) Remove 5th shift fork bolt (2).
6) Remove gear shift fork (3), sleeve & hub assembly, synchro-
nizer levers, synchronizer ring and 5th gear all together. Use
gear puller for removal if spline fitting of hub is tight.
7) Unfasten caulking of counter shaft nut (2), install input shaft
5th gear (1) and special tool to stop rotation of shafts, and
(A)
then remove counter shaft nut (2).
2
Special tool
(A) : 09927-76060
8) Remove input shaft 5th gear, needle bearing and then
counter shaft 5th gear (3). Gear puller (4) would be neces-
sary if spline fitting of counter shaft 5th gear is tight.
9) Remove bolts (1), and take off left case plate (2) and bearing
set shim.
10) Remove bearing set shim.
Assembly
1) Install counter shaft left bearing outer race (1) to bearing
cone, and tap cup using special tool and plastic hammer (2).
Special tool
(A) : 09913-70123
MANUAL TRANSAXLE (M15 ENGINE MODEL) 7A2-21
Advertisement
Table of Contents
