Suzuki Ignis Service Manual page 1396

MANUAL TRANSAXLE (M15 ENGINE MODEL) 7A2-41
9) Install circlip (1) and confirm that circlip is installed in groove
securely.
Install needle bearing (2) of separated steel cage type, apply
oil to bearing.
With synchronizer outer ring (3), center cone (4) & inner ring
(5) put together and installed to 2nd gear (6) as shown in fig-
ure.
[A] : SECTION A - A
10) Press-fit 3rd gear (2) and spacer (1) using special tools and
press.
CAUTION:
Press-fit 3rd gear (2) and spacer (1) first, and then 4th
gear later separately so that counter shaft will not be
compressed excessively.
Special tool
(A) : 09923-78210
(B) : 09913-84510
11) Press-fit 4th gear (2) using the same procedure as step 10).
12) Install left bearing cone (1) using special tools and hammer.
NOTE:
For protection of right bearing cone (3), always support
shaft with special tool as illustrated.
Special tool
(A) : 09923-78210
(B) : 09913-80113