Suzuki Ignis Service Manual page 1478

Step
3 Check pressure control solenoid valve resistance
1) Turn ignition switch OFF
2) Disconnect valve body harness connector on
automatic transmission.
3) Check for proper connection to solenoid at
"BRN/YEL" and "LT GRN" circuit.
4) Check resistance of pressure control solenoid.
See Fig.
Resistance between pressure control solenoid
valve terminals of transmission side valve body
harness connector:
5.0 – 5.6 Ω (at 20°C (68°F))
Resistance between pressure control solenoid
valve terminals of transmission side valve body
harness connector and transmission body:
Infinity
Is check results satisfactory?
Fig. for Step 3.
1. Valve body harness connector on harness
2. Valve body harness connector on transaxle
3. Ground (transaxle)
Action Yes
Intermittent trouble or
faulty TCM. Check for
intermittent referring to
"Intermittent and Poor
Connection" in Sec-
tion 0A. If OK, substi-
tute a known-good
TCM and recheck.
5 4 3 2 1
10 9 8 7
6
1
3
AUTOMATIC TRANSAXLE 7B-73
No
Replace pressure control
solenoid valve or valve
body harness.
2