DOOR LOCK ACTUATOR
ON-VEHICLE INSPECTION
1) Remove door trim (front, rear or back) and disconnect door
lock actuator (3) coupler.
2) Connect battery (+) terminal to terminal "L" and (-) terminal
to terminal "UL". Check that door lock actuator (3) is on
"LOCK" position.
If check result is not satisfied, replace.
3) Connect battery (+) terminal to terminal "UL" and (-) terminal
to terminal "L". Check that door lock actuator (3) is on
"UNLOCK" position.
If check result is not satisfied, replace.
[A] : FRONT DOOR
[B] : REAR DOOR
[C] : BACK DOOR
KEYLESS ENTRY SYSTEM (IF EQUIPPED)
DOOR LOCK CONTROLLER
INSPECTION
Refer to DOOR LOCK CONTROLLER of POWER DOOR LOCK
SYSTEM (IF EQUIPPED) in this section.
DOOR LOCK ACTUATOR
INSPECTION
Refer to DOOR LOCK ACTUATOR of POWER DOOR LOCK
SYSTEM (IF EQUIPPED) in this section.
BODY ELECTRICAL SYSTEM 8-29