Table of Contents
Advertisement
3E-6 REAR SUSPENSION
8) Lower hoist and vehicle in non-loaded condition, tighten
absorber lower bolt (1) and lateral rod body side nut (2) to
specified torque.
Tightening torque
Rear shock absorber lower bolt
(a): 63 N·m (6.3 kg-m, 45.5 lb-ft)
Lateral rod body side nut
(b): 100 N·m (10.0 kg-m, 72.5 lb-ft)
9) If equipped with LSPV, check and adjust LSPV spring refer-
ring to "LSPV (Load Sensing Proportioning Valve) Inspection
and Adjustment" in Section 5A and "Brake Fluid Pressure
Test (if equipped with LSPV)" in Section 5.
Bump Stopper Removal and Installation
Installation
1) Install bumper stopper.
NOTE:
Before installing bushing, apply soap water on it.
2) Install wheel (1) and tighten wheel bolts (2) to specified
torque.
Tightening torque
Wheel bolt (a): 95 N·m (9.5 kg-m, 69.0 lb-ft)
Trailing Arm Removal and Installation
Installation
1) Install trailing arm (1) to vehicle body and rear axle (or axle
housing) referring to figure for proper installing direction of
bolts (2).
Tighten front nut (3) and rear nuts (4) temporarily by hand at
this step.
A : Vehicle out side
B : Vehicle center side
Advertisement
Table of Contents
