Table of Contents
Advertisement
15) When fixing boot (1) to joint housing (2) with boot big band
Drive shaft boot fixing position
Left side shaft of vehicle with manual transaxle
"a" : 153.8 – 163.8 mm (6.06 – 6.45 in.)
Left side shaft of vehicle with automatic transaxle
"a" : 143.5 – 153.5 mm (5.65 – 6.04 in.)
Right side shaft
"b" : 182.8 – 192.8 mm (7.20 – 7.59 in.)
CAUTION:
• Bend each boot band against forward rotation (A).
• Do not squeeze or distort boot when fastening it with
For left side shaft of Z13DT engine model
CAUTION:
To prevent any problem caused by washing solution, do
not wash boots. Degreasing boots with cloth is allowed.
1) Wash each component (except boots).
2) Clean boots with cloth.
3) Install wheel side boot on shaft temporarily.
4) Apply grease in the supplied parts to the inside of joint hous-
Grease color : Dark brown
Amount : Approximately 85 g (3.0 oz)
5) Fit wheel side boot onto grooves of housing and shaft.
6) Place new wheel side boot big band onto boot putting band
1
2
(3), adjust so that measurements become as indicated
below. For fixing boot band, refer to steps 4) to 6).
bands. Distorted boot caused by squeezing air may
reduce its durability.
[A] : Left side shaft
[B] : Right side shaft
After wash, dry each component completely by blowing air.
ing.
outer end (1) against forward rotation (2) as shown in figure.
FRONT DRIVE SHAFT 4A-13
Advertisement
Table of Contents
