Table of Contents
Advertisement
WARNING:
• For handling and storage of a live seat belt preten-
sioner, select a place where the ambient temperature
below 65° ° ° ° C (150° ° ° ° F), without high humidity and away
from electric noise.
• Never carry the seat belt pretensioner by the wire or
connector of the pretensioner.
• When placing a live seat belt pretensioner on the work-
bench or other surface, be sure not to lay it with its
exhaust hole (1) provided side facing down. It is also
prohibited to put something on its face with an exhaust
hole (1) or to put a seat belt pretensioner on top of
another.
Otherwise, personal injury may result.
DEPLOYED AIR BAG (INFLATOR) MODULE AND ACTI-
VATED SEAT BELT PRETENSIONER
WARNING:
• The air bag (inflator) module and seat belt pretensioner
immediately after deployment/activation is very hot.
Wait for at least 30 minutes to cool it off before pro-
ceeding the work.
• Do not apply water, oil, etc. to deployed air bag (infla-
tor) module and to activate seat belt pretensioner.
• After an air bag (inflator) module has been deployed,
the surface of the air bag may contain a powdery resi-
due. This powder consists primarily of cornstarch
(used to lubricate the bag as it inflates) and by-prod-
ucts of the chemical reaction. As with many service
procedures, gloves and safety glasses should be
worn.
• Wash your hands with mild soap and water after com-
pleting the work.
Refer to the procedure described under "DEPLOYED AIR BAG
(INFLATOR) MODULE AND ACTIVATED SEAT BELT PRETEN-
SIONER DISPOSAL".
AIR BAG SYSTEM 10B-51
Advertisement
Table of Contents
