How To Register Ignition Key - Suzuki Ignis Service Manual

HOW TO REGISTER IGNITION KEY

1
(A)
(C)
Register the ignition key with a built-in transponder in Immobilizer
Control Module by using the following procedure.
CAUTION:
When registering the ignition key including a transpon-
der into the immobilizer control module by using Suzuki
scan tool, confirm that the knob color of the ignition key
to be registered for the vehicle is dark gray. The ignition
key with wrong knob color cannot be registered.
1) Prepare SUZUKI scan tool and cartridge for immobilizer con-
trol system.
2) With ignition switch OFF, connect SUZUKI scan tool to data
link connector (DLC) (1) located on underside of instrument
panel at driver's seat side.
(A) : 09931-76011 (SUZUKI scan tool)
(B) : Immobilizer cartridge
(C) : 09931-76030 (16/14 pin DLC cable)
NOTE:
For operation procedure of SUZUKI scan tool, refer to
SUZUKI scan tool operator's manual.
(B)
3) Prepare ignition key with a built-in transponder (1). And then
turn ignition switch ON by using it.
4) Number of Transponder codes for ignition key with a built-in
transponder that can be registered in Immobilizer Control
Module is limited to 4. If needed, clear all Transponder
codes for ignition key with a built-in transponder that have
been registered in Immobilizer Control Module by executing
the "CLR. TRANS COD (CLEAR TP CODE)" command in
the SELECT MODE menu by using SUZUKI scan tool.
NOTE:
When "CLR. TRANS COD (CLEAR TP CODE)" command
is executed with the immobilizer indicator lamp ON, it
remains ON even after execution of that command is
over. It will start flashing when the ignition switch is
turned OFF once and then turned ON after some sec-
onds.
IMMOBILIZER CONTROL SYSTEM 8G-23