Table of Contents
Advertisement
"a"
2
1
18) Caulk reduction drive gear nut (1).
19) Apply A/T fluid to planetary gear assembly (1), then fit it to
planetary ring gear assembly.
1
20) Check for correct installation of planetary gear assembly as
follows.
Measure the distance "a" by using micrometer caliper (1)
and straightedge (2). If measured value is out of specifica-
tion, remove planetary gear assembly and reinstall it prop-
erly.
Distance between planetary gear assembly and mating
surface of transaxle case
"a": 51.3 – 52.0 mm (2.020 – 2.047 in.)
"a"
AUTOMATIC TRANSAXLE 7B-185
Advertisement
Table of Contents
