Suzuki Ignis Service Manual page 1260

"b"
(A)
5) Place new wheel side boot small band (1) onto boot putting
band outer end (2) against forward rotation (3) as shown in
figure.
6) Fasten boot small band by using special tool.
NOTE:
• Small band must not come out of its installation sec-
tion.
• Be sure to caulk small band securely until complete
contact "b" is obtained.
Special tool
(A) : 09943-57010
7) Install damper (1) on right side drive shaft according to
dimension specified below.
Damper installation position
For M15 engine model
"a" : 174 – 180 mm (6.85 – 7.09 in.)
For Z13DT engine model
"a" : 157 – 163 mm (6.18 – 6.42 in.)
8) Fasten damper band referring to step 6) in assembly.
9) Set new differential side boot small band and differential side
boot on shaft temporarily.
10) Install cage (1) onto shaft by using pipe (2).
Pipe diameter
"a" : 25 mm (0.98 in.) or more
"b" : 33 mm (1.30 in.) or less
CAUTION:
Install cage directing smaller outside diameter side to
wheel side.
FRONT DRIVE SHAFT 4A-11