Table of Contents
Advertisement
2, (a), "A"
3
1
3
10) Tighten shift fork shaft bolt (2) to which thread lock cement
has been applied.
"A" : Cement 99000-32110
Tightening torque
Shift fork bolt
(a) : 10 N·m (1.0 kg-m, 7.5 lb-ft)
11) Using special tool, install new circlip (1) to input shaft (3) in
specified direction as shown in the figure.
Special tool
09900-06107
4. Polished surface
12) Clean mating surface of both left case (2) and side cover (1),
apply sealant to side cover (1) as shown in figure by such
amount that its section is 1.5mm (0.059 in.) in diameter,
mate it with left case and then tighten bolts.
"B" : Sealant 99000-31260
Tightening torque
Side cover bolt (a) : 10 N·m (1.0 kg-m, 7.5 lb-ft)
Gear Shift Shaft, Input Shaft and Counter
Shaft Removal and Installation
Removal
1) Remove gear shift and select shaft assembly referring to
"Gear Shift and Select Shaft Assembly Removal and Instal-
lation" in this section.
2) Remove fifth gear referring to "Fifth Gear Disassembly and
Assembly" in this section.
3) Remove snap ring (1) using special tool.
(A)
2
Special tool
(A) : 09900-06107
2. Input shaft
3. Input shaft left bearing
1
MANUAL TRANSAXLE (M15 ENGINE MODEL) 7A2-25
Advertisement
Table of Contents
