Table of Contents
Advertisement
10B-56 AIR BAG SYSTEM
FORWARD
3
5
2
SDM
WARNING:
During service procedures, be very careful when han-
dling a Sensing and Diagnostic Module (SDM).
Be sure to read "SERVICE PRECAUTIONS" before start-
ing to work and observe every precaution during work.
Neglecting them may result in personal injury or inactiva-
tion of the air bag system when necessary.
REMOVAL
1) Disconnect negative cable at battery.
2) Disable air bag system. Refer to "DISABLING AIR BAG
SYSTEM" of "SERVICE PRECAUTIONS".
3) Remove center console boxes (1) by removing screws and
clips.
4) Disconnect SDM connector (2) from SDM (3).
5) Remove SDM (3) (with SDM plate (5)) as an assembly from
vehicle.
CAUTION:
Do not separate SDM (3) and SDM plate (5).
Advertisement
Table of Contents
