Table of Contents
Advertisement
(A)
4) Remove oil seal (1) using special tool.
Special tool
(A) : 09913-50121
1
5) Install oil seal (1) facing its spring side upward.
Use special tool and hammer for installation.
Special tool
(B) : 09913-85210
6) Apply grease to oil seal lip and at the same time check drive
shaft where oil seal (1) contacts and make sure of its
smoothness.
"A" : Grease 99000-25010
7) Install transfer referring to "Transfer Dismounting and
Remounting" in Section 7D.
8) Insert front drive shafts referring to "Drive Shaft Assembly
Removal and Installation" in Section 4A.
9) Install ball stud and stabilizer mount brackets referring to
"Wheel Hub and Steering Knuckle Removal and Installation"
and "Stabilizer Bar and Bushings Removal and Installation"
in Section 3D.
10) Install tie-rod end referring to "Suspension Control Arm/
Bushing Removal and Installation" in Section 3D.
11) Fill transaxle oil as specified referring to "Manual Transaxle
Oil Change" in this section, and make sure that oil has been
sealed with oil seal.
MANUAL TRANSAXLE (M15 ENGINE MODEL) 7A2-7
Advertisement
Table of Contents
