Volkswagen Passat 1995 Official Factory Repair Manual page 1774

VAG 1551 Scan Tool (ST), connecting and selecting 'Engine Electronics' address word 01
Rapid data transfer
Select function XX
X DTC recognized
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU07....
HELP
Notes:
There must not be a malfunction stored in DTC
memory and there must be no malfunction
detected during the diagnosis.
If the CYCLE bit has a 1, the diagnosis is
completed and the test sequence can be
implemented.
The specifications for the function bits must
only be satisfied during the diagnostic phase
(ACTIVE bit = 1).
An "x" shown as the specification in the
diagnosis status table means the display can
show either "0" or "1".
Work step: 2
Indicated on display
- Press buttons -0- and -2- to select "Check DTC
Memory" function 02 and press -Q- button to
confirm input.
The number of malfunctions stored or "No DTC
recognized" will be shown on the display.
- Locate and eliminate malfunctions printed out as
per DTC table Page 01-14
- Press
button.
Page 29 of 77
01-35
.
12/6/2004