Volkswagen Passat 1995 Official Factory Repair Manual page 1721

Motronic Fuel Injection and Ignition system, component layout
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Disconnect -blue- 2 pin harness connector from
Engine Coolant Temperature sensor (G62).
- Set digital potentiometer VAG 1630 -side A- to
15 k and using jumper wires from V\N 1594
adaptor kit, connect to disconnected harness
connector.
- Operate starter. The injectors must spray
uniformly.
- Switch off ignition and check fuel injectors for
leaks. No more than 2 drops/minute may leak
from each injector.
Note:
When installing the injectors ensure that the O-
rings are not/will not be damaged. To facilitate
installation, moisten O-rings slightly with oil.
- Check and erase DTC memory, eliminate any
stored codes if necessary
DTC code "Engine Coolant Temperature sensor
- G62" created by performing the check will be
erased.
Page 58 of 59
24-45
page 01-5 . The
6/12/2004