Volkswagen Passat 1995 Official Factory Repair Manual page 2210

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.28.1
- Disconnect 5-pin connector (arrow) from Ignition
Coil -N152-.
Checking voltage supply
- Connect multimeter to terminal 1 (Ground -GND-)
+5 (B+) of disconnected connector for ignition coil
for voltage measurement.
- Switch ignition on.
Specified value: at least 11.5 V
- Switch ignition off.
If there is no voltage:
- Check wire between 5-pin connector terminal 1
and Ground (GND) for open circuit according to
wiring diagram.
Wire resistance: max. 1.5
Page 20 of 23
28-20
12/6/2004