Motronic Fuel Injection and Ignition system, component layout
Rapid data transfer
Select function XX
Reading measuring value block
Input display group number XX
Read measuring value block 3
1 2 3 4
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Intake Air Temperature sensor, checking
- Remove Intake Air Temperature sensor (G72)
and reconnect to harness connector.
- Seal threaded hole (vacated by sensor).
- Connect VAG 1551 Scan Tool and select
"engine electronics" (address word 01); select
while engine is idling
Ignition).
Display will appear as shown:
HELP
- Select Function 08 "Read measuring value
block" and confirm with Q.
Display will appear as shown:
HELP
- Input 03 for display group 03 and confirm with Q.
Display will appear as shown:
(1...4 = Display zones)
Note:
If something different is indicated on the display:
Scan Tool operating instructions
- Read Intake Air Temperature in display zone 4.
Specification: Approx. ambient temperature
Page 48 of 59
page 01-3
(Fuel and
6/12/2004
24-35