Volkswagen Passat 1995 Official Factory Repair Manual page 1886

Multiport fuel injection and ignition system
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU07.24.1
Checking basic voltage
- Disconnect 4-pin connector -2- (brown) to HO2S 2
-G108- (after three way catalytic converter).
- Connect multimeter using test leads from VW 1594
to measure voltage at ECM connector terminals 3
and 4.
- Start engine and measure basic voltage.
Specification: 0.40-0.50 volts
- Switch ignition off.
If the specification is not attained:
- Check HO2S wiring
If the specification is attained:
- Replace Heated Oxygen Sensor (HO2S) 2 -G108-
(after three way catalytic converter).
Page 47 of 126
Page 24-47 .
12/6/2004
24-46