Volkswagen Passat 1995 Official Factory Repair Manual page 2202

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.28.1
- Check wires between test box and 3-pin connector
to Engine Control Module (ECM) for open circuit
according to wiring diagram.
Terminal 2 + socket 44
Terminal 3 + socket 56
Wire resistance: max. 1.5
- Check wire between 1-pin connector terminal 3
and relay carrier -G1/4- for open circuit according
to wiring diagram.
Wire resistance: max. 1.5
- Check wires for short circuit to each other.
Specified value:
If no malfunction is found in the wires and there was
voltage between terminals 1 + 3:
- Replace Camshaft Position (CMP) Sensor -G40-
Page 28-3 , item 1 .
If no malfunction is found in the wires and there was
no voltage between terminals 1 + 3:
- Replace Motronic Engine Control Module (ECM) -
J220- Page 24-101
Page 12 of 23
.
28-12
12/6/2004