Volkswagen Passat 1995 Official Factory Repair Manual page 2114

Engine components,checking
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.24.2
- Erase DTC memory of Engine Control Module
(ECM) Page ST-25
Reset/erase diagnostic data.
- Generate readiness code
If indication remains at approx. -46.5 C:
- End diagnosis and switch ignition off.
- Check wires according to wiring diagram
Page 24-60 .
Continuation of test if display shows 141.0
C:
- Disconnect 2-pin connector from Intake Air
Temperature (IAT) Sensor (arrow).
If indication jumps to approx. -46.5 C:
- End diagnosis and switch ignition off.
- Replace Intake Air Temperature (IAT) Sensor -
G72- Page 24-14
- Erase DTC memory of Engine Control Module
(ECM) Page ST-25
Reset/erase diagnostic data.
- Generate readiness code
Page 33 of 59
, Diagnostic mode 4:
Page ST-50 .
, item 16 .
, Diagnostic mode 4:
Page ST-50 .
24-59
12/6/2004