Volkswagen Passat 1995 Official Factory Repair Manual page 2259

Diagnostic function, selecting
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.ST.2
Diagnostic mode 2: Check operating
conditions
Function
This diagnostic mode displays the operating
requirements at which an emission-relevant
malfunction was detected and stored by the
Engine Control Module (ECM) or Transmission
Control Module (TCM).
Work procedure
- Connect diagnostic tester
- Depending on desired operating condition:
switch on ignition or start engine and let run at
idle.
- Under address word 33, select "Diagnostic
mode 2: Check operating conditions."
- Select the desired operating condition "PID
XX".
Note:
The following list only serves as an overview.
The operating conditions are sorted by the PID
(parameter-identifications).
Page 6 of 34
ST-18
Page ST-7 .
12/6/2004