Too Large; Display Remains On "Too Large; Press Button Of Vas5056; Replace Wiring Harness - Volkswagen Passat 1995 Official Factory Repair Manual

Airbag system, On Board Diagnostic (OBD), vehicles from 10.94
Displayfield
2 Passenger's side Airbag
Igniter -N131-
3 Not used for
troubleshooting
4 Not used for
troubleshooting
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.BD01.01.2
Designation Display
contents
correct No malfunction found
Trig. GND
- Visually check wiring
- Check connectors of applicable circuit for
POS
correct seating, at the same time watch
display
too small
- If display changes to "correct", erase DTC
Memory
- Disconnect connector between adapter wire
and airbag unit
Display changes to "too large"
- Replace airbag unit
Display remains on "too small"

- Replace wiring harness

- Connect test box VAS5056 to passenger's
side harness

- Press button of VAS5056

too large

Display changes to "too small"
- Replace airbag unit

- Display remains on "too large"

- Replace wiring harness
Page 25 of 28
Correction
Page 01-43 .
01-41
12/7/2004