Volkswagen Passat 1995 Official Factory Repair Manual page 1835

VAG 1551 Scan Tool (ST), connecting and selecting 'CARB/OBD II' address word 33
x Malfunction recognized
Module 10* MIL off Module 1A*
P0422
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU07.01.3
DTC memory, mode 3
- Press button -3- to select mode 3 DTC
memory.
Display will appear as shown
*Module 10 or 1A will be activated (alternately):
Module 10 = Engine Control Module (ECM) -
J220-
Module 1A = Transmission Control Module (TCM)
-J217-
MIL OFF / ON = MIL switched OFF or ON
- Press
button, any stored DTCs will be
displayed in sequence
Display will appear as shown (example)
- Press
button.
Notes:
If two or more DTCs are stored, the cause of the
malfunction could be attributed to the second or
following malfunction. Interpreting stored DTCs,
Page 01-14 , DTC table
After malfunctions have been repaired, Clear DTC
memory ( Page 01-97
readiness code again
- Press -C- button to exit mode 3.
Page 13 of 17
) and create the
Page 01-33 .
12/6/2004
01-96