Volkswagen Passat 1995 Official Factory Repair Manual page 2255

Diagnostic function, selecting
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.ST.2
Diagnostic mode 1: Check measured
values
Function
In this diagnostic mode, all emissions-relevant
measured values are displayed.
Requirement
Coolant temperature must be at least 80 C
PID 05, Coolant temperature.
Work procedure
- Connect diagnostic tester
- Depending on the desired operating condition:
switch on ignition or start engine and let run at
idle.
- Under address word 33, select "Diagnostic
mode 1: Checking measured values."
- Select desired measured values "PID XX".
Note:
The specified values for the measuring values
can be found under the respective component-
and function tests.
The following list only serves as an overview.
The measuring values are sorted according to
the PID (parameter-identifications).
Page 2 of 34
ST-14
Page ST-7 .
12/6/2004