Volkswagen Passat 1995 Official Factory Repair Manual page 1429

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Test sequence
- Disconnect 3-pin connector from ignition coil
Page 28-4 , item 8 .
Checking voltage supply
- Measure voltage supply between terminals 1 + 3
of disconnected connector -4-.
- Switch ignition on.
Specified value: at least 11.5 V
- Switch ignition off.
If there is no voltage:
- Check wire between 3-pin connector terminal 1
and Ground (GND) for open circuit according to
wiring diagram.
Wire resistance: max. 1.5
- Check wire between 3-pin connector terminal 3
and relay carrier -G1/4- for open circuit
according to wiring diagram.
Wire resistance: max. 1.5
If there is no malfunction in voltage supply:
- Check activation
Page 29 of 31
28-27
Page 28-28 .
6/12/2004