Volkswagen Passat 1995 Official Factory Repair Manual page 1475

Selector lever mechanism, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Locking cable (vehicles with
ignition key removal lock),
adjusting
Note:
Adjustment of the locking cable must
always be performed in the installed
position.
Installation position of locking cable
Procedure
- Shift selector lever into position "1".
- Turn ignition key toward right (start
position) and release.
- Adjust play of a = 0.7mm between
lever -1- and locking pin -2- by sliding
locking cable protective sleeve.
- Tighten bolt for locking cable bracket
to 6 Nm in this position.
- Shift selector lever into position "P"
and turn ignition key into end
position.
- Remove ignition key.
It must only be possible to
remove ignition key in this
position.
Selector lever cannot be
switched out of position "P".
Page 44 of 47
37-35
6/12/2004