Volkswagen Passat 1995 Official Factory Repair Manual page 1310

Components of engine, checking
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Generate readiness code
If indication remains at approx -46.5 C:
- End diagnosis and switch ignition off.
- Check wires according to wiring diagram
Page 24-58 .
Continuation of test if indication is 141.0 C:
- Disconnect 2-pin connector -1- from Intake Air
Temperature (IAT) Sensor -G72- (-2-).
If indication jumps to approx. -46.5 C:
- End diagnosis and switch ignition off.
- Replace Intake Air Temperature (IAT) Sensor
G72- Page 24-16
- Erase DTC memory of Engine Control Module
(ECM) Page ST-26
Reset/erase diagnostic data.
- Generate readiness code
Page 33 of 62
24-57
Page ST-52 .
, item 5 .
, Diagnostic mode 4:
Page ST-52 .
6/12/2004