Volkswagen Passat 1995 Official Factory Repair Manual page 1288

Components of engine, checking
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Checking signal and Ground wires of Mass
Air Flow (MAF) Sensor
- Connect test box to control module wiring
harness Page ST-11
wiring test.
- Check wires between test box and 4-pin
connector -1- to Engine Control Module (ECM)
for open circuit according to wiring diagram.
Terminal 2 + socket 16
Terminal 4 + socket 17
Wire resistance: max. 1.5
- Check wires for short circuit to each other, to
vehicle Ground (GND) and to B+.
Specified value:
If no DTCs are found in wires:
- Replace Mass Air Flow (MAF) Sensor -G70-
Page 24-19 , item 5 .
- Erase DTC memory of Engine Control Module
(ECM) Page ST-26
Reset/erase diagnostic data.
- Generate readiness code
Page 11 of 62
24-35
, connect test box for
, Diagnostic mode 4:
Page ST-52 .
6/12/2004