Volkswagen Passat 1995 Official Factory Repair Manual page 1501

Electrical components of transmission control, removing and installing, checking
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Checking wiring
- Disconnect 12-pin harness connector at
transmission.
- Check wires between test box and 12-pin
connector to Transmission Control Module
(TCM) for open circuit according to wiring
diagram.
Terminal 1 + socket 67
Terminal 12 + socket 6
Wire resistance: max. 1.5
- Check wires for short circuit to each other, to
vehicle Ground (GND) and to B+.
Specified value:
If no malfunctions are found in wires:
- Replace Transmission Fluid Temperature
Sensor -G93-:
Repair Manual, 4 Spd. Automatic Transmission
01M, Repair Group 38; removing and installing
valve body
- Erase DTC memory of Transmission Control
Module (TCM) Page ST-26
4: Reset/erase diagnostic data.
- Generate readiness code
Page 23 of 27
38-21
, Diagnostic mode
Page ST-52 .
6/12/2004