Volkswagen Passat 1995 Official Factory Repair Manual page 1531

Diagnostic mode, selecting
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Under address word 33, select "Diagnostic
mode 3: Check DTC memory."
The number of stored malfunctions or "0
malfunctions detected" is displayed.
- End diagnosis and switch ignition off.
- Repair stored malfunctions according to DTC
table:
SAE P0xxx-DTCs
SAE P1xxx-DTCs
SAE P2xxx-DTCs
SAE P3xxx-DTCs
Note:
The DTC table is sorted by SAE code.
"Emission"-relevant malfunctions are
additionally indicated in the instrument cluster
via the Malfunction Indicator Lamp (MIL).
In Diagnostic mode 2, it can be determined at
which operating condition a malfunction was
detected and stored by the Engine Control
Module (ECM)
mode 2: Checking operating conditions.
Erase DTC memory after repairing malfunction
Page ST-26 , Diagnostic mode 4:
Reset/erase diagnostic data.
Page 11 of 35
Page ST-56 ,
Page ST-75 ,
Page ST-93 ,
Page ST-95 .
Page ST-19 , Diagnostic
ST-24
6/12/2004