Volkswagen Passat 1995 Official Factory Repair Manual page 1834

VAG 1551 Scan Tool (ST), connecting and selecting 'CARB/OBD II' address word 33
Mode 42 0 PID 0 Module 10
Freeze Frame Data
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU07.01.3
Freeze frame data, mode 2
Note:
If a malfunction is detected by the Engine Control
Module (ECM) and is then stored,
simultaneously, the operating conditions existing
at the time the malfunction was stored will also
be stored, and can be interrogated via mode 2.
Breakdown of the (PID) identification parameters
Page 01-87 current data.
- Press button 2 to select mode 2 freeze frame
data.
Display will appear as shown
- Press
button.
Module 10* or 1A* will be activated (alternately):
Module 10 = Engine Control Module (ECM) -
J220-
Module 1A = Transmission Control Module (TCM)
-J217-
- Press
button, and the operating conditions will
be printed out as a block, assuming there is a DTC
stored in DTC memory.
- Mode 2 can be exited by pressing the C button.
Page 12 of 17
01-95
12/6/2004