Volkswagen Passat 1995 Official Factory Repair Manual page 1431

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
- Erase DTC memory of Engine Control Module
(ECM) Page ST-26
Reset/erase diagnostic data.
- Generate readiness code
If LED does not flicker:
- Check wires according to wiring diagram
Page 28-29 .
Checking wiring
- Connect test box to control module wiring
harness Page ST-11
wiring test.
- Check wire between test box and 3-pin
connector to Engine Control Module (ECM) for
open circuit according to wiring diagram.
Terminal 2 + socket 8
Wire resistance: max. 1.5
- Check wires for short circuit to B+ or Ground
(GND).
Specified value:
If no malfunctions are found in wires:
- Replace Motronic Engine Control Module (ECM)
-J220- Page 24-105
Page 31 of 31
28-29
, Diagnostic mode 4:
Page ST-52 .
, connect test box for
.
6/12/2004