Volkswagen Passat 1995 Official Factory Repair Manual page 2201

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.28.1
Checking voltage supply
- Connect multimeter to terminal 1 (B+) + 3 Ground
(GND) of disconnected connector for Camshaft
Position (CMP) sensor for voltage measurement.
- Switch ignition on.
Specified value: at least 11.5 V
- Switch ignition off.
If there is no voltage:
- Check wires according to wiring diagram
28-11 .
Checking wiring
- Connect test box to control module wiring harness
Page ST-10 , connect test box for wiring test.
Page 11 of 23
28-11
Page
12/6/2004