Volkswagen Passat 1995 Official Factory Repair Manual page 1717

Motronic Fuel Injection and Ignition system, component layout
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Fuel injectors, removing and
installing
Removing
- Disconnect spark plug connector
using 3277.
- Remove ignition wire guides -1- and -
2-.
- Pull PCV breather valve off cylinder
head cover and breather hose to
EVAP canister purge regulator valve
1 off intake manifold upper section.
- Disconnect intake hose from Mass
Air Flow sensor.
- Disconnect harness connectors from
Throttle Position sensor, PCV heater
element, Idle Air Control valve and
Intake Air Temperature sensor.
- Disconnect accelerator cable at
throttle body and support bracket (do
not remove retainer).
- Pull coolant hoses from throttle body
and seal off.
- Unclip fuel lines on cylinder head
cover.
- Pull vacuum hose off fuel pressure
regulator.
- Pull vacuum hose off brake servo.
- Remove intake manifold upper
section.
Page 54 of 59
24-41
6/12/2004