Volkswagen Passat 1995 Official Factory Repair Manual page 2236

Transmission control electrical components, removing and installing, checking
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.38.1
Requirements
Selector lever must be in -P- position.
Ground (GND) connections to transmission
must be OK.
Ignition switched off.
Work sequence
- Connect test box to control module wiring
harness Page ST-10
wiring test.
Checking resistance
- Measure resistance of solenoid valves at test
box between sockets:
Component
Solenoid valve 1 -
N88-
Solenoid valve 2 -
N89-
Solenoid valve 3 -
N90-
Solenoid Valve 4 -
N91-
Page 23 of 26
, connect test box for
Bushing Specified value
55 + 67 55.0 to 65.0
54 + 67 55.0 to 65.0
9 + 67 55.0 to 65.0
47 + 67 4.5 to 6.5
38-23
12/6/2004