Volkswagen Passat 1995 Official Factory Repair Manual page 1419

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW...
Ground (GND) connections between engine,
transmission, and chassis must be OK.
Ignition switched off.
Checking voltage supply
- Disconnect 3-pin connector for Camshaft
Position (CMP) Sensor -G40- on distributor.
- Connect multimeter to outer terminals of the
disconnected connector for Camshaft Position
(CMP) sensor for voltage measurement.
- Switch ignition on.
Specified value: at least 9.0 V
- Switch ignition off.
If there is no voltage:
- Check wires according to wiring diagram
Page 28-18 .
Page 19 of 31
28-17
6/12/2004