Volkswagen Passat 1995 Official Factory Repair Manual page 2213

Ignition, servicing
http://ebahn.bentleypublishers.com/vw/servlet/Display?action=Goto&type=repair&id=VW.B4.FU08.28.1
If no malfunction is found in the wires and there
was voltage between terminals 1 +5:
- Replace Ignition Coil -N152-
6 .
- Erase DTC memory of Engine Control Module
(ECM) Page ST-25
Reset/erase diagnostic data.
- Generate readiness code
Checking secondary resistances
- Check secondary resistances at terminal 4
between
Cyl. 1 and cyl. 6,
Cyl. 3 and cyl. 4,
Cyl. 2 and cyl. 5.
Specified value: 3.6 to 4.4 k
If specified values are not obtained:
- Replace Ignition Coil -N152-
6 .
- Erase DTC memory of Engine Control Module
(ECM) Page ST-25
Reset/erase diagnostic data.
- Generate readiness code
Page 23 of 23
Page 28-4 , item
, Diagnostic mode 4:
Page ST-50 .
Page 28-4 , item
, Diagnostic mode 4:
Page ST-50 .
28-23
12/6/2004