Subaru B9 TRIBECA WX 2007 Manual page 859

asieps_tobira.book 19 ページ ２０１２年２月１０日 金曜日 午後３時２６分
11.Rear Wiper Motor
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Remove the rear wiper arm. <Ref. to WW-18,
REMOVAL, Rear Wiper Arm.>
3) Remove the rear gate lower trim. <Ref. to EI-51,
REMOVAL, Rear Gate Trim.>
4) Disconnect the harness connector of wiper mo-
tor assembly.
5) Remove the bolts to remove wiper motor assem-
bly (A).
B: INSTALLATION
1) Install in the reverse order of removal.
2) Be sure that the pivot cap with the arrow mark
facing up, as shown in the figure.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion".
<Ref. to WW-3, REAR WIPER, COMPONENT,
General Description.>
Rear Wiper Motor
C: INSPECTION
1) Connect the battery to the wiper motor connec-
tor and confirm that wiper motor operates.
(A)
2) Connect the battery to the terminals to the con-
nector, then run the wiper motor at low speed and
disconnect the terminal in mid motion.
WW-00183
3) Connect the battery and confirm that the wiper
motor stops at the automatic stop position after the
wiper motor operates at low speed again.
WW-00185
WW-19
WIPER AND WASHER SYSTEMS
2 1
4 3
WW-00186
2 1
4 3
WW-00187
2 1
4 3
WW-00032