Subaru B9 TRIBECA WX 2007 Manual page 59

asieps_tobira.book 8 ページ ２０１２年２月１０日 金曜日 午後３時２６分
AIRBAG SYSTEM
2. Airbag Connector
A: PROCEDURE
1. POWER SUPPLY, BUCKLE SWITCH
1) How to disconnect:
(1) Move the slide lock (A) in the direction of ar-
row.
(2) While holding the slide lock (A) in moved po-
sition, disconnect the connector.
CAUTION:
When pulling the slide lock or disconnecting
connector, be sure to hold the connector, not
the harness.
2) How to connect:
Holding the connector (A), and push it in carefully
until a clicking sound is heard.
CAUTION:
Be sure to insert the connector in until it is
locked. Then pull it gently to make sure that it is
locked.
Airbag Connector
(A)
AB-00721
AB-00016
AB-8
2. DRIVER'S AIRBAG MODULE, CURTAIN
AIRBAG MODULE AND PRETENSIONER
1) How to disconnect:
(1) Using a flat tip screwdriver, pry the push
lock upward to unlock.
(2) Pull and disconnect the connector from the
driver's airbag module assembly or retractor as-
sembly.
2) How to connect:
Connect the connector in the reverse order of dis-
connecting. At this time, be sure to insert the push
lock until a clicking sound is heard.
CAUTION:
• Be sure to insert the connector in until it is
locked. Then pull it gently to make sure that it is
locked.
• Be sure to push the push lock in securely.
NOTE:
The connector can not be connected when the
push lock is in the lock position. To connect the
connector, set the push lock to unlock position.
AB-00478
AB-00479
AB-00480