Subaru B9 TRIBECA WX 2007 Manual page 569

asieps_tobira.book 12 ページ ２０１２年２月１０日 金曜日 午後３時２６分
INSTRUMENTATION/DRIVER INFO
3. Combination Meter
A: REMOVAL
1) Disconnect the ground cable from the battery.
2) Set the tilt steering at the lowest position.
3) Remove the console box. <Ref. to EI-38, RE-
MOVAL, Console Box.>
4) Remove the control panel. <Ref. to AC-32, RE-
MOVAL, Control Panel.>
5) Remove the instrument panel lower cover. <Ref.
to EI-36, REMOVAL, Instrument Panel Lower Cov-
er.>
6) Remove the console side panel. <Ref. to EI-39,
REMOVAL, Center Console.>
7) Remove the meter hood.
8) Remove the screws of combination meter (two
for upper side, two for lower side) and pull the com-
bination meter.
9) Disconnect the connector in the rear side of
combination meter to remove meter.
CAUTION:
• Be careful not to damage the meter or instru-
ment panel.
• Pay particular attention to avoid damaging
the meter glass.
Combination Meter
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
• Make sure the electrical connector is con-
nected securely.
• Make sure that each meter operates normal-
ly.
• When the combination meter of model with
immobilizer has been replaced, be sure to per-
form the registration of immobilizer.
IDI00189
IDI-12