Subaru B9 TRIBECA WX 2007 Manual page 300

asieps_tobira.book 7 ページ ２０１２年２月１０日 金曜日 午後３時２６分
6. Rearview Camera System
A: WIRING DIAGRAM
<Ref. to WI-123, WIRING DIAGRAM, Rearview Camera System.>
B: INSPECTION
Symptom
The screen of rear view camera is not displayed. (The naviga-
tion screen is displayed normally.)
Marker is not displayed.
C: ADJUSTMENT
1) Park vehicle on a level surface with wide space
around the vehicle rear side.
2) Adhere tapes on the floor of the vehicle rear side
as shown in the figure, as the datum point of mak-
ers.
NOTE:
Use a tape of approx. 30 mm width in bright colors
as a criterion.
(A) 500 mm (19.7 in)
(B) 2180 mm (85.8 in)
(C) Tapes as criteria
3) While pressing DEST key and INFO key of nav-
igation system, turn the ignition switch to ON to en-
ter the test mode.
4) Touch REAR CAMERA MODE in the monitor
and go to the maker adjustment mode.
CAUTION:
Do not select other than REAR CAMERA
MODE; the navigation system or the navigation
monitor may not operate normally.
Rearview Camera System
1. Check the back sensor for each connection: Make sure that
the back sensor is ON. <Ref. to ET-6, CHECK THE BACK
SENSOR, INSPECTION, Navigation System.>
2. Check the rear view camera connection.
3. Check the rear view camera control module.
1. Check the rear view camera connection.
2. Check the rear view camera control module.
5) Touch the monitor to change maker pattern.
(B)
(C)
NOTE:
(A)
Adjust the marker so that the marker laps over the
(C)
tape or is placed outside of the tape.
ET-00231
ET-7
ENTERTAINMENT
Repair order
(A) (A)
(A)
(C) (C)
(C)
(B) (B)
(B)
CONFIRM AROUND YOUR VEHICLE FOR SAFETY
(A) Rear bumper
(B) Tapes adhered in step 2)
(C) Marker
ET-00220