Subaru B9 TRIBECA WX 2007 Manual page 596

asieps_tobira.book 21 ページ ２０１２年２月１０日 金曜日 午後３時２６分
9. FUNCTION SETTING (ECM CUSTOMIZING)
1) On the «Main Menu» display screen, select the {Each System Check}.
2) On the «System Selection Menu» display screen, select the {Integ. unit mode}.
3) On the «Integ. Unit mode failure diag» display screen, select the {ECM customizing}.
4) Change the setting.
• List of function setting item (ECM customizing)
NOTE:
Even if changes are made to items that are not equipped, the contents are not confirmed and do not operate.
Initial setting
Data
value
Off delay time Normal
Auto lock time 30 sec.
Rr defogger op.
15 min.
mode
Wiper deicer
15 min.
op. mode
Security Alarm
ON
Setup
Impact Sensor
OFF
Setup
Alarm monitor
ON
delay setting
Lockout
ON
prevention
Impact Sensor OFF
Subaru Select Monitor
Customize
setting
Delay time below can be selected by setting.
After door closed
OFF 0 sec.
Short 3 sec.
Normal 5 sec.
Long 8 sec.
Workable when Auto locking is set to "ON" and Auto-
0 — 60
matic locking setup is "ON". Time can be changed by
sec.
10 seconds: 0 (OFF) — 60 (maximum).
Automatically stops in 15 minutes after switch is
15 min.
turned to ON.
Repeats active condition for 15 minutes and
Continuous inactive condition for 2 minutes until switch is turned
to OFF.
Automatically stops in 15 minutes after switch is
15 min.
turned to ON.
Repeats active condition for 15 minutes and
Continuous inactive condition for 2 minutes until switch is turned
to OFF.
Security alarm (hazard, horn or siren) in active
ON
condition
OFF Security alarm in inactive condition
Workable when Impact Sensor Setup is set to "ON"
ON
Impact sensor in active condition
Impact sensor in inactive condition
OFF (Set Impact Sensor Setup of model without impact
sensor to "OFF".)
After doors are locked by keyless entry system oper-
ated, Alarm monitor starts in following time.
ON Delay time is 30 seconds.
OFF Delay time is 0 seconds.
Lockout prevention in inactive condition
ON (Lockout prevention does not operate if safety knob is
locked by hand.)
OFF Lockout prevention in inactive condition
Vehicle is controlled in impact sensor equipped mode.
(Set impact sensor to "OFF" in model without impact
ON sensor. If impact sensor is set to "ON", hazard, horn or
siren operate after doors are locked by keyless entry
system operated (Alarm monitor starting).)
Vehicle is controlled in impact sensor no-equipped
OFF
mode.
LAN(diag)-21
LAN SYSTEM (DIAGNOSTICS)
Remarks Destination Specifications
After key unlock
0 sec.
10 sec.
20 sec.
30 sec.
Set to "ON" when an
optional impact sensor is
installed.
Not supported by North
American specifications