Subaru B9 TRIBECA WX 2007 Manual page 423

asieps_tobira.book 16 ページ ２０１２年２月１０日 金曜日 午後３時２６分
GLASS/WINDOWS/MIRRORS
11.Rear Door Glass
A: REMOVAL
1) Remove the rear door trim. <Ref. to EI-35, RE-
MOVAL, Door Trim.>
2) Remove the sealing cover. <Ref. to EB-21, RE-
MOVAL, Rear Sealing Cover.>
3) Apply the protective tape (1) to the areas as
shown in the figure.
(1)
4) Operate the power window switch to move the
glass to the position shown in the figure, and then
remove the two bolts through service holes.
5) Remove the sash retaining bolts (A), and loosen
the retaining nuts (B).
(B)
Rear Door Glass
GW-00487
GW-00488
(A)
GW-00491
GW-16
6) Move the sash (C) upward, and move the nut (B)
to the position on rear door as shown in the figure.
7) Detach the rear part of door glass from sash (1),
and move it backward (2). Tilt the door glass in-
ward, and move it upward to remove (3).
(1)
(3)
(2)
CAUTION:
• Since the gear may be disengaged, do not
turn regulator in the closing direction after re-
moving glass.
• Avoid impact and damage to the glass.
8) Remove the glass run rubber.
9) Remove the door sash.
B: INSTALLATION
Install in the reverse order of removal.
CAUTION:
Make sure that the glass run rubber is placed
securely in door frame and sash.
Tightening torque:
Refer to "COMPONENT" of "General Descrip-
tion". <Ref. to GW-4, REAR DOOR GLASS,
COMPONENT, General Description.>
(C)
(B)
GW-00489
GW-00490